Atmel AT91CAP7A STK User Manual

CAP^TMCUSTOMIZABLE MICROCONTROLLERS

AT91CAP7A-STK^®Starter Kit

for CAP Customizable Microcontroller

The CAP™ Starter Kit is the ideal vehicle for low-cost, no-risk evaluation of the customization capabilities

of Atmel’s CAP microcontroller. It is intended to familiarize the user with the CAP concept and architecture,

and is an ideal vehicle for students of electronic engineering to consolidate their knowledge of system-

on-chip design, both hardware and software.

CAP comprises a microcontroller-based system-on-chip with ARM^®processor, memories, peripherals and

standard interfaces, together with a Metal Programmable (MP) Block for application-specific functions.

The CAP Starter Kit facilitates the mapping of application-specific IP blocks into its FPGA that

emulates the functionality of the CAP MP Block, while at the same time providing

a development platform for software for the ARM processor. This enables the

hardware and software of simple applications, or modules of more complex

applications, to be tested at close to operational speed.

CAP Starter Kit Board

The AT91CAP7A-STK Starter Kit is built on a single PCB, including:

nAT91CAP7E ARM7TDMI^®-Based

nFour Analog Inputs

Microcontroller System-On-Chip

nLight Sensor

n64M Bytes SDRAM Memory, 3.3V

nTemperature Sensor

n256M Bytes NAND Flash, 3.3V

nAltera^®Cyclone^®II EP2C8F256C7N (256BGA)

nVoltage Potentiometer

nVoltage Regulators (1.2V, 2.5V and 3.3V)

nAccess Points for CAP7 Power Measurements

nEight LED’s Four Push Buttons

nJTAG ICE Connector (CAP7)

nJTAG ISP Connector (FPGA)

nPOR Circuit for FPGA

nAltera Configuration PROM -EPCS4SI8N

n40-Lead Extension Connector (x3) for I/O

Access

n2.8 inch TFT Color LCD

nTwo Serial Ports (One Connected to the CAP7

Debug Unit)

nPOR Circuit for CAP7

nOne USB 2.0 Full Speed Device Port

n50 MHz OSC

nMini Joy Stick